Playing Back Tapes

You can play back type I, type II, and type IV tapes without changing any settings.

Playing Back a Tape

1 Press 0for cassette deck.

To stop playing, press 7.

To fast-wind to the left or to the right, press ¢ or 4

while the tape is not running.

The tape direction indicator (3or 2) starts flashing quickly on the display.

To remove the cassette, press 0 for cassette deck.

To play both sides — Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

Press REV.MODE on the unit.

REV.MODE

 

• Each time you press the button, reverse mode changes as follows:

2 Put a cassette in with the exposed part of the tape down.

3 Close the cassette holder gently.

4 Press TAPE 23.

TAPE

The unit automatically turns on and the tape play starts. The tape direction indicator

(3or 2) flashes slowly on the display.

Each time you press the button, the tape direction changes.

3: plays the front side.

2 : plays the reverse side.

The tape direction lamp on the unit starts flashing to indicate the tape running direction.

REC

When the tape plays to the end, the deck automatically

stops if the reverse mode is set to or . (See “To play both sides — Reverse Mode.”)

: The deck automatically stops after playing both sides of the tape. (Stops when playback in the

2direction is finished.)

: The deck continues to play both sides of the tape until 7is pressed.

: The deck automatically stops after playing one side of the tape.

The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

– 15 –

Page 17
Image 17
JVC UX-P7 manual Playing Back Tapes, Playing Back a Tape, Press 0for cassette deck, To play both sides Reverse Mode