Basic and Common Operations
Continued
Setting the Clock
Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, “0:00” starts flashing on the display.
You can set the clock when the unit is either turned on or in standby mode.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 1.
On the remote control ONLY:1 | When the unit is in standby mode, | DISPLAY/ | |||
CLOCK SET | |||||
|
| ||||
| press and hold DISPLAY/CLOCK |
|
|
| |
|
|
|
| ||
| SET until the hour indication starts |
|
|
| |
| flashing. |
|
|
|
•When the unit is on, press DISPLAY/CLOCK SET to enter clock mode, then press and hold DISPLAY/ CLOCK SET.
2 Press 4 or ¢ to adjust the hour, then press DISPLAY/CLOCK SET.• When you press and hold 4 or ¢, the hour indication changes continuously.
The minute indication starts flashing. | DISPLAY/ | ||
CLOCK SET | |||
|
|
|
|
DISPLAY/CLOCK SET.
•When you press and hold 4 or ¢, the minute indication changes continuously.
“CLOCK OK” appears on the display for a DISPLAY/
CLOCK SET
while and the
•When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY/CLOCK SET. | DISPLAY/ | ||
• Each time you press the button, the display | CLOCK SET | ||
|
|
| |
changes the clock indication and the normal |
|
|
|
|
|
| |
indication alternately. |
|
|
|
To change the clock
Repeat steps 1 to 3 of the procedure “Setting the Clock.”
Turning On the Power
To turn on the unit, press STANDBY/ON.
STANDBY/ON
The standby lamp on the unit goes off.
•When you press the source
To turn off the unit (standby), press STANDBY/ON again.
The standby lamp on the unit lights red.
•“0:00” flashes on the display until you set the
•A little power is always consumed even while the unit is in standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
8