BEAT CUT
Listening to FM and AM (MW) Broadcasts Continued

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER/

BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM (MW).

•Each time you press the button, the band alternates between FM and AM (MW).

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive FM MODE

or noisy, press FM MODE so that the MONO indicator lights up on the display. Reception will improve.

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

2 Press and hold ¢ or 4 (or ¡/¢ or 4/1 on the unit) for more than 1 second.

•¢ (¡/¢): Increases the frequencies.

•4 (4/1): Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢ or 4 (or ¡/¢ or

4/1 on the unit).

When you repeatedly press ¢ or 4 (or ¡/¢ or 4/1 on the unit)

The frequency changes step by step.

To reduce the beat when listening to an AM (MW) station—Beat Cut

On the remote control ONLY:

While recording an AM (MW) broadcast, beats may be heard (which are never heard when listening to the broadcast without recording it). If this occurs, press BEAT CUT repeatedly, while recording, until the beats are reduced.

•Each time you press the button, the display alternates between “CUT–1” and “CUT–2.”

10