Setup
Installation (continued) |
| Outputting images |
|
|
|
Mounting hood cover (provided)
1 Align the hood cover with the groove on top of the viewfinder screen and insert from the top.
2 Secure with the screw found under the center of the viewfinder screen.
1 When setting the POWER switch on remote control or camera to AONB, image will be output on the viewfinder.
Note：
●Depending on the system environment, it may take up to 40 seconds before the image is output.
Screw
Adjusting position
1 To adjust the angle of the viewfinder, loosen the Pan/ Tilt Lock Handle and secure it at an appropriate angle for visible viewing.
Note：
●The LCD screen may be difficult to see depending on the view angle. Use the angle right in front of the screen.
Panning
Tilt
Panning and Tilt Lock Handle
Adjusting picture quality
1 Turn the [BRIGHT] control to adjust the
brightness of the screen.
To brighten, turn to the right.
Caution：
●If the [BRIGHT] control is turned completely to the left, images may not be output.
MENU
STATUS
BRIGHT |
| [BRIGHT] control |
| 6 | [CONTRAST] control |
CONTRAST 5 |
| |
PEAKING | 5 | [PEAKING] control |
| 6 |
|
1:1
FOCUS
ASSIST
2 Turn the [CONTRAST] control to adjust the
contrast of the screen.
To increase the contrast, turn to the right.
3 Turn the [PEAKING] control to adjust the peaking.
To sharpen the contour, turn to the right.
Note：
●You can adjust the freqency band where the contour is emphasized with the [PEAKING] control under the [PEAKING FREQ.] item of the [SHOOTING ASSIST] menu screen. (A Page 14)
Caution：
●After the power switch of the camera or the remote control unit is turned off, wait for 10 seconds and above to turn on the switch again.
●Turning ON/OFF the power switch quickly may cause malfunction.
10