Setup

Installation

Mounting on KA-HD250U

1 Rotate the lock level as shown by the arrow () in the diagram below.

2 Align the bracket for viewfinder mount on top of KA-HD250U with the groove at the viewfinder mount base and insert from the back of the camera head

Mount Base

Bracket for viewfinder mount

Lock Lever

3 Rotate the viewfinder lock lever as shown in the direction of the arrow () and secure the viewfinder to KA-HD250U.

Lock Lever

Connecting VF cable

When connecting the VF cable, be sure to turn off the POWER switch on the camera or on the remote control unit first. Connect the viewfinder [VF CABLE] terminal to the KA-HD250U VF output terminal with the provided VF cable.

VF Cable

1 Insert the provided VF cable completely into the [VF CABLE] terminal.

2 Loosen the set screw on the cable holder, tilt the holder at an angle and insert the VF cable from the bottom into the groove on the holder.

Cable holder

Set screw

VF Cable

3 Press the cable holder squarely against the main unit and secure the set screw.

If the cable holder is slanted, the set screw cannot be secured and it may damage the screw hole of the main unit.

(Good)

(No good)

Caution：

To reduce emission of unwanted radio waves, install a core filter on the VF cable connecting GY-HD250U and KA-HD250U.

●Use the core filter (black) provided with GY-HD250U.

●Install the core filter (black) as close as possible to KA-HD250U.

Removing the viewfinder

1 Rotate the lock lever in an anticlockwise direction as shown in the diagram below.

2 While pressing the Release button, slide the viewfinder toward the back of the camera head and remove.

Push

Release button

Lock Lever

Core filter (black)

Note：

●Use KA-HD250U with identification letter from (A) onwards on the name plate for connecting to this unit. If there is no identification letter, consult JVC dealer.

9