Memo:

●If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.

●When camera images are acquired by the Built-in Viewer or another client and if this acquisition exceeds the distribution capability of camera, the video images may not appear on the Motion Detection page. When you use the Motion Detection page, turn the Built-in Viewer and another client Off.

●The area valid for motion detection is displayed in blue.

●When motion is detected, the area around the screen is highlighted in red.

A Motion Detection

 

The display screen showing the motion detection area is divided into 13

Area

 

(horizontal) by 9 (vertical) blocks (for aspect ratio 4:3) or into 15 (horizontal)

 

 

 

by 9 (vertical) blocks (for aspect ratio 16:9). You can specify whether to

 

 

 

enable motion detection in each block.

 

 

 

When you click a block for motion detection. the block turns blue and it

 

 

 

becomes a target of detection. When you click the right-hand mouse button

 

 

 

on the blue block, the blue display is cancelled and detection will not be

 

 

 

applied to this block. If you move the mouse while pressing the right- or left-

 

 

 

hand button, you can set up multiple blocks at once.

 

 

 

When you set all blocks and press the [OK] button, the motion detection is

 

 

 

made valid for each block.

 

 

 

B Motion Detection

 

Turns the motion detection ON or OFF.

 

 

 

[Set values: ON, OFF]

 

 

 

Memo:

 

 

 

 

 

 

 

 

 

● You cannot set this to [ON] when the frame rate is set to 25 fps.

 

 

 

 

 

 

 

C Level

 

Sets a sensitivity of motion detection.

 

 

 

Increasing the number raises the detection sensitivity level and the

 

 

 

detection becomes more sensitive.

 

 

 

[Set values: 0 to 4 to 10]

 

 

 

D All Mask

 

Deactivates detection regions.

 

 

 

E Clear Mask

 

Performs motion detection on all blocks.

 

 

 

 

 

 

 

 

 

* The [Set values] in bold letters are factory defaults.

Memo:

 

 

 

 

 

 

 

 

 

 

●The area display position servers as a reference. Always check its operation.

●A single screen is divided into 135 blocks (13 horizontal by 9 vertical blocks) (for aspect ratio 4:3) or into 108 blocks (12 horizontal by 9 vertical blocks) (for aspect ratio 16:9). Set the angle of view so that the size of object for motion detection is larger than the size of multiple blocks.

●Masks cannot be set in a zoomed screen.

●When you open the setting page for motion detection, it is displayed in the fixed (full-screen) size.

Note:

●Flickers of fluorescent lamps may cause motion detection.

●A brightness change due to the light source may be detected as motion.

●The motion detection function is not intended to prevent theft or fire. Also, this function may not function properly under certain conditions of object and settings.

Our company is not liable for any accident or damage that occurs.

●When [Tampering Detection] or [Audio Detection] is set to AONB, the motion detection function cannot be used.

55