Caution
●The dome cover is an optical parts. Handle with care.
●When mounting the dome cover, make sure that there is no dirt inside the cover.
●Tighten the dome cover securely.
5 Mount the fall prevention wire
Mount the fall prevention wire, which is attached to the camera, to the fall prevention wire fixing bracket of the ceiling clamping bracket.
Caution
●Be sure to connect the fall prevention wire. Otherwise, the camera may fall.
●To prevent danger, do not leave the fall prevention wire dangling by the camera.
6 Mount the camera
●Align the ADB mark (blue)/(red) inside the camera with the ADB mark (blue)/(red) on the ceiling clamping bracket.
●Insert the camera into the ceiling clamping bracket until you hear a click sound and mount it securely.
7 Check that the camera fixing lock knobs (x2) are sticking out.
If the camera is mounted on securely, the camera fixing lock knobs (x2) will stick out a little.
Fall prevention 5 wire fixing bracket
D mark 6 | D mark (red) |
| |
(blue) |
|
| Fall Prevention Wire |
7 
During mounting
After 
mounting
Note:
●Before mounting the camera, check that the camera fixing lock knobs are not locked (i.e., lock knobs are on top). The camera cannot be mounted if the lock knobs are locked.
●When pulling out the cables from the side, remove the cable cover of the camera. (A Page 16)
8Lock
When the camera is mounted on the ceiling clamping bracket, lower the camera fixing lock knobs (x2) in the direction of the arrow and secure the camera such that it does not fall off.
Camera fixing lock knob (x2)
Memo:
●To remove the camera, follow the reverse procedures.
Caution
●Be sure to check that the camera fixing lock knobs (x2) are locked securely. Otherwise, the camera may fall.
●After mounting, check that the camera is mounted securely. Improper mounting may cause the camera to fall off.
19