A LAN Cable
B Power cable
CAlarm signal cable
Note:
●Do not connect an AC 24 V cable to AC 100 V power supply. The camera will be damaged. If the wrong cable is connected, the internal circuit may be damaged. Do not use the camera. Bring it to your nearest JVC service center for inspection.
●For safety reasons, turn on the power only after all the connection is complete.
●To supply AC 24 V, use a AC 24 V supplying power unit that is insulated from AC 100 V line.
6 Handling cables
Thread the provided wire clamp through the wire clamp fixing hole of the ceiling clamping bracket to tie all the wires.
Wire clamp fixing hole 
Tie here
Wire clamp
Note:
●To prevent the cables from tangling and coming off, be sure to thread a wire clamp through the wire clamp fixing hole to tie the cables.
7 Mount the terminal cover
Return the terminal cover that was removed in step 3 to its original position. The direction to pull out the cables changes according to the mounting method of the camera.
Pulling out the cables from the side
Terminal cover
Pulling out the cables from the top
Fall Prevention Wire
(To go under the terminal cover)
Terminal cover
Note:
●Be sure to mount the terminal cover to prevent foreign objects or dust from entering.
●When pulling out the cables from the top, make the fall prevention wire go under the terminal cover and pull it out together with the other cables.
●When pulling out the cables from the side, remove the cable cover of the camera.
Cable cover
17