| During Initial Startup | |
Example (continued) |
|
|
|
|
|
|
|
|
Note :
●Do not connect LAN1 to the internet. If the internet is busy or the relay equipment fails, you may not be able to save important camera images. To maintain full recording capacity, it is recommended that a dedicated network be used. Be sure to connect the LAN1 camera network to the same segment. (Do not use the address translation of NAT and NAPT etc. or a router.)
●If you connect LAN2 to the internet from a surveillance computer, you will need to configure IP Masquerading.
●Communication between LAN1 and LAN2 is not possible. Nor is it possible to configure a camera connected to LAN1 from the surveillance computer connected to LAN2. In order to configure a camera connected to LAN1, it is necessary to connect the computer for configuring cameras to LAN1.
●LAN1 and LAN2 are incompatible with QoS. Sound may not be played normally depending on the condition of the circuit.
●The default LAN1 IP address is 192.168.0.253 and the default LAN2 IP address is 192.168.1.253. To change the address, use [INSTRUCRTIONS].
●When a single network camera is registered with multiple units of
●Do not connect a broken hub, router or deteriorated network cable etc. Doing so may prevent the system from operating properly.
●Connection to a keyboard is not recommended.
Perform language setting and automatic camera registration when starting up
Before Starting Up.
●The DHCP setting is required for the IP camera beforehand. Start up the
●Refer to the user manual supplied with the camera for instructions on how to specify the IP camera settings.
●By default, [Time Zone] is set to
Keypad
|
|
|
| WARNING |
|
|
|
|
|
LIVE/BROWSE |
|
|
|
|
|
| |||
OPERATE |
|
|
| ALARM |
|
|
|
|
|
|
|
|
|
|
|
|
| REV | FWD |
SELECT | *1/' | HDD |
|
|
|
|
| ||
|
|
|
| LOCK |
|
|
|
|
|
REC CONTROL |
|
|
|
|
|
|
|
|
|
PTZ/PRESET |
|
|
|
|
| ||||
SERIAL |
|
|
| FUNCTION SEARCH | KEY ALARM CLEAR | REC/STOP | STOP(PB) | PLAY |
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
| SKIP |
| CANCEL | ZOOM OUT | ZOOM IN | ENTER |
|
|
|
|
|
[16/ENTER] [KEY] Button | |
Button | Button |
Start up
1 Turn on the power switch at the rear panel.
●
12