Attaching the Marine Case to the Camera

1 Pull the power/mode switch lever of the marine case in the direction of the arrow (Q), and rotate it to lock it (R).

If the power/mode switch lever is not locked, it may touch or damage the camera when the camera is put into the case.

5 Insert the camera into the marine case.

Inserting the provided silica gel between the camera and marine case prevents the inside of the marine case from steaming up.

Silica gel

Tighten the grip belt.

Base attachment groove

Base

Marine case internal base

2 Attach the base in the correct way for your model of camera. (☞ pg. 7)

•Line up the tripod screw hole on the base of your camera with the base holes of the case, and tighten the screw.

•Install the battery (and insert an SD card if needed) beforehand.

For cameras that are equipped with Base A, attach the lens hood.

3 Setup the camera (please refer to your camera’s instruction manual).

•Turn off the ﬂ ash and light. (presence of a ﬂ ash/ light differs according to the model.)

•Switch off the power.

•It is recommended to set to the auto recording mode.

•Open the lens cover.

If it is difﬁ cult to open buckles, use the buckle opener.

Hexagonal wrench (small)

Lock in all 4 places.

NOTE

The risk of water leakage is extremely high if the O-ring is twisted, if you forget to attach it, or if something is trapped in the seal.