Recording the Video/Still Image Files
Before recording
Submerge the marine case with the camera equipped into a bathtub or water tank full of fresh water.
Gradually increase the amount of time the marine case is submerged as shown below.
•1st time: 5~10 seconds
•2nd time: 30 seconds ~ 1 minute
•3rd time: 3 minutes ~ 5 minutes (try operating the levers and buttons while the marine case is submerged).
NOTES
•Always have someone hold the marine case for you when diving into, or getting out of water.
•If for any reason water leakage occurs, remove the camera battery. It may cause the camera to explode.
1 Pull the marine case power/mode switch lever to release the lock, and switch on the camera’s power.
Rotate the lever to switch on the camera’s power. The camera’s power lamp lights.
8 Switching between video/still modes
Switch modes by rotating the lever.
2 Press the video recording start/stop button or the still image shooting button to start recording.
Still image shooting button
Zooming (Telephoto)
Zooming (Wide angle)
Video recording start/stop button
3 When you have finished recording, rotate the power/mode switch lever to turn the camera’s power off.
The camera’s power lamp goes out.
NOTE
Sometimes, due to sudden shaking or impact to the marine case, the camera’s drop detection function operates to switch off the camera’s power.
When [VIDEO MANAGEMENT FILE IS BROKEN. TO RECORD/PLAYBACK VIDEO, RECOVERY IS REQUIRED. RECOVER?] is displayed, press the REC button to recover the fi le.
6
