Advanced operations
See page 21 for button locations.
Tray lock
You can lock the tray and prohibit the unwanted disc ejection.
On the center unit ONLY:
While the system is turned off
DISC 1
Press and hold
•The system turns on and “LOCKED” appears on the display window.
•If you try to eject the disc, “LOCKED” appears to indicate that the tray is locked.
To cancel
Carry out the same operation again.
•The system turns on and “UNLOCKED” appears on the display window.
Sound settings
IMPORTANT
Before using the remote control for the following operation;
•Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
D E C. A / P C M
2 Press Cursor Y/5to select the item you want to set.
•DEC (Decode):
When you play an external source (AUX D is selected as a source) that was encoded with Dolby D or DTS Digital Surround, the following symptoms may occur;
•No sound comes out at the beginning of playback.
•Noise comes out while searching for or skipping chapters or tracks.
A/PCM (Auto/PCM):
Normally select this. The system automatically detects the incoming signals.
DD:Select this if the symptoms above occur when
playing a disc (or software) encoded with Dolby D.
DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround.
3 Press Cursor 3/2to make an adjustment or selection.
Example:
D E C. D D
The adjustment is set and the display automatically disappears a few seconds later.
NOTE
•When “DD” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or Cindicator flashes.)
31