JVC YU30052-572 manual Power, Camera

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

•If you want to turn the tally lamp off, see page 27.

STOP RECORDING

•The power indicator lights and the camcorder enters the Record–Standby Mode.

•The scene you’re aimed at appears on the viewfinder screen, with the word “PAUSE” superimposed upon it.

START SHOOTING

LOAD A CASSETTE

12EN		RECORDING Basic Recording
	LENS COVER	NOTE:
		You should already have performed the procedures listed
	Switch
		below. If not, do so before continuing.
		● Power (☞ pg. 4)
		● Tape Length (☞ pg. 8)
		● Grip Adjustment (☞ pg. 10)

	Slide EJECT to open the cassette holder, then insert
	1 the cassette with the label facing out. Press PUSH to
POWER	ensure the holder is closed and locked.
Start/Stop Button	ENTER RECORD–STANDBY MODE
Power indicator	Slide the LENS COVER open/close switch to open
	2 the lens cover, then set the power switch to
	“CAMERA”.

		3 Press the Recording Start/Stop button.
25min
	Tally lamp

Tape remaining time indicator				Press the Recording Start/Stop button again to stop
60min	59min	3min	4 recording.
				•The camcorder re-enters the Record-Standby
1min (Blinking)		2min (Blinking)
				mode.

0min (Blinking)

*---min.....(Now calculating)

NOTES:

●A cassette holder can’t be opened unless a power supply is attached.

●There may be a delay after you slide EJECT until the holder opens. Do not use force.

●The tape’s remaining time is displayed in the viewfinder as shown.

●The indicated remaining time is approximate.

●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

●The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been selected (☞ pg. 8).

●When using a 60–minute tape, the tape remaining time displayd will not be accurate.

●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

●If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations, the camcorder’s power shuts off automatically. Set the Power switch to “POWER OFF”, and then back to “CAMERA” to turn the camcorder on again.

●If you’re recording on a cassette from the middle, use the RETAKE function (☞ pg. 14) to find the end of the last recording so you don’t erase any of it.

●The LENS COVER warning blinks for about 8 seconds when the camcorder is turned on, when the cover is closed.