Kalorik BL 24242, BL 25280 manual How To Clean

Manual Speed setting

Turn the rotary knob from “MIN” position to “MAX” position to select the desired speed. The blender runs from low speed to high speed.

In manual speed setting, the “ice button”, “smoothie button” and “pulse button” are disabled

•Blender stops running if the current is above the limitation and the pilot light of “pulse button” flashes, press “pulse button” again and the appliance resume working.

•No matter in what mode the blender is working, just lift glass jug from the motor block to stop the appliance. To resume operating the blender, set the speed rotary knob back to “off” position, replace the jug, select the “On” position and choose the function or turn the rotary knob to select speed.

HOW TO CLEAN

•Always unplug from outlet before cleaning.

•For a quick rinsing of the pouring jar (for example between two preparations), you can use clear water and switch on your appliance for a few seconds. In this case, do not use any detergent.

•For a full cleaning of the pouring jar, remove it from the motor block and unscrew the base of the blade assembly by turning it anti-clockwise to disassemble it (this will make the cleaning easier). Then you can clean the blades and the jar with soapy water and rinse thoroughly with clear water. Dry before assembling. Therefore you only have to screw the blades support by turning it clockwise in the bottom of the pouring jar (tighten vigorously in order to avoid leaks). Attention, do not lose the sealing ring during this operation.

•You can wipe the motor block with a soft damp cloth.

•IMPORTANT : the borosilicate jar of your blender is designed to support sudden temperature variations up to 50°C / 125°F. After preparing an icy preparation, it is important to avoid cleaning the jar with very hot water immediately afterwards, or the glass may shatter. Likewise, after preparing a hot preparation like soup, please do not rinse with very cold water immediately afterwards.

7 USK BL 24242/BL 25280 - 090602