•Place the small (11) or the large filter (12) correctly in the filter holder.
•According to the required number of cups, fill the small or large filter with 1 or 2 measures of special espresso coffee powder using the measuring spoon (13).
•Then press the coffee with the tamper (13).
•Insert the filter holder (3) in the support of the filter holder (14). Therefore, place the handle (6) of the filter holder to the left and check that the filter locking lever (15) is as far as possible from the filter by pulling it to you. Insert the filter holder in its support and turn it firmly to the right until it blocks. The filter holder should be as far to the right of the closing zone as possible and at least in the middle of the appliance. This will avoid that the filter holder comes out of its housing as the pressure rises when the coffee is flowing. If the filter holder does not fit in the closing zone and at least in the middle of the appliance, do not operate your appliance, remove the filter holder and position it again as described here above.
•Place one or two cup(s) on the grid of the drip tray (4) and under the dripping holes of the filter holder.
•Check that the function selector (9) is in off position and place the ON/OFF switch (5) in ON position. The red power light (2) of the switch will illuminate and indicate that the appliance is switched on.
•Wait until the blue ready light (8) lights up. When it comes on, turn the function selector (9) to 
. The pump will start functioning and a few seconds later the coffee will start coming out through the openings of the filter holder. At the beginning you can hear that the pump makes more noise than when the water starts flowing. This is absolutely normal.
•When the cup(s) is (are) filled, turn the function selector (9) back to “0" and the water will stop flowing.
•To prepare other espressos, empty the used coffee of the filter. Therefore you have to remove the filter holder by turning it to the left. CAUTION: Be careful when you remove the filter holder because the metal parts may still be hot. Never remove the filter holder when the function selector is not in “0” position. Put the filter locking lever (15) against the edge of the filter in order to block it and beat the filter holder above the bin. Rinse the
6 | USK EXP 4 - 070830 |
