Kalorik USK JK 28345 manual Before The First Operation, Assembly page 5/28

Models: USK JK 28345

1 28
Download 28 pages 1.08 Kb
Page 5
Image 5
BEFORE THE FIRST OPERATION

 

Copies of the I/B. Please reproduce them without any

 

changes except under special instruction from Team

 

International BELGIUM. The pages must be reproduced and

 

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

 

210 mm height). When folding, make sure you keep the good

Fax +32 2 359 95 50

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

 

￿

CAUTION: read, understand and follow all the important safeguards and operating instructions in this Use and Care guide before using this product.

BEFORE THE FIRST OPERATION

For a perfect taste, operate the jug kettle with fresh water in order to clean any residue left from the manufacturing process. When the appliance has cooled down, repeat the process 3 times with fresh water, before rinsing.

OPERATION

Always remove the jug from the power base before filling it or before any operation.

Open the lid by pressing its release button and fill the tank with fresh water, paying attention not to fill under the minimum mark and above the maximum mark on the water level indicator. Too little water may result in the kettle switching off before the water has reached temperature.

Close the lid by pressing it down until it you hear a click. Make sure it closes correctly.

Put the jug onto the power base, plug into the wall socket. The temperature “212” will flash for approx. 10 seconds. Your kettle is operational.

Your kettle can be used both for boiling water or bring it to your desired temperature. This is particularly interesting for the preparation of hot beverages, most especially tea, as the ideal brewing temperature can be different from one sort to the other.

Press the on/off button on the control panel to turn the kettle on. The water boiling temperature “212” (°F) will flash for a few seconds, during which the temperature can be changed to your liking. For this, press “+” or “-“ to set the kettle to the desired temperature. When the screen stops blinking, the temperature is set and the kettle will start warming the water. The red “Power” LED is lit.

When the kettle reaches the desired temperature, the kettle will turn off and will produce 5 short beeps. The water temperature is

5

USK JK 28345 - 091125

Assembly page 5/28

Page 5
Image 5
Kalorik USK JK 28345 manual Before The First Operation, Assembly page 5/28