Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
10 USK STP 20159 - 110127
Assembly page 10/24
Fax +32 2 359 95 50
TROUBLE SHOOTING

PROBLEM CAUSE SOLUTION

Steam press cannot be
opened with the
handle
Locking knob is in
locked position
Turn the locking knob
to the unlocked
position
Steam press becomes
warm but DOES NOT
remove wrinkles.
Temperature setting is
not high enough for the
fabric attempted.
Gradually increase the
temperature until
obtaining the desired
results.
Press DOES NOT get
warm.
Temperature has not
been selected
Make a proper
selection.
Press is not plugged
into an outlet.
Plug the appliance in.
Automatic Shut-Off has
engaged. The pressing
plate has been raised
for more than 15
minutes without use.
Press “ON/OFF” again.
No Steam Water Level is too low. Fill the water tank.
Controls have not been
properly set.
If suitable for the fabric,
make a selection to a
higher temperature.
Wait for the steam
ready light to come on.
If not use spray misting
bottle as directed.
Water drips from the
pressing plate.
Burst of steam button
has been pressed too
long.
Don t press the burst of
steam button more
than 5 seconds
continuously.
The handle will not
move into the
automatic maximum
pressure position.
Item on the ironing
board is too thick to use
this pressure.
Use lighter pressure on
thicker items. Use
added steam for
wrinkles.