Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame.
•Place the area to be pressed onto the ironing board.
•Place the pressing cushion under the dart, seam etc.
•Make sure the area to be pressed is raised and lower the pressing plate. The raised area is the only area the plate should contact. NOTE: Do not attempt to lower the pressing plate to its lowest position or lock the pressing plate against the ironing board with the pressing cushion in place. You MAY DAMAGE the steam press by doing so.
•Raise the pressing plate after a few seconds.
STORING
•Water may be left in the water tank, because it will not drip out if the machine is stored in an upright position. However, it is recommended that if the machine will be stored for some time, that all the water in the unit should be drained by pressing the burst of steam button until all of the water is pumped out.
•Press “ON/OFF”, the red power light will go out. Disconnect the plug from the outlet. Leave appliance in open position.
•Wait for the steam press to cool completely (approximately 30 minutes).
•When cool, lower the pressing plate onto the ironing board pushing the handle to its lowest position.
•Turn the locking knob to the locked position. This should prevent the steam press from opening while being moved or stored.
•Loosely wrap the electric cord and place it in the opening at the front of the base of the ironing board. You are now ready to store the unit.
CLEANING
•To clean the pressing plate, place the pressing cushion in the center of the ironing board. Place a clean towel over the pressing cushion and the ironing board. Set the temperature control to its maximum setting. When the ready light comes on and the steam ready light goes off, gently lower the pressing plate onto the pressing cushion. With water in the water tank, press the burst of steam button 6 to 7 times. Be careful to avoid
8 | USK STP 20159 - 110127 |
