emptying the dust container
The dust container should be emptied when the dust and dirt reaches the MAX level.
Always switch the vacuum off, then switch off at the power outlet and unplug prior to replacing filters or emptying the dust container.
To remove the dust container, ensure the unit is down on its wheels; remove the dust container by pressing down on the “Press and Lift” button 
on the dust container. Once released carefully lift the container upwards.
To empty the dust container simply place it above the rubbish bin; press the “push to empty” button. The bottom of the container will release and the dust and compiled dirt will be dispensed.
IMPORTANT: DO NOT USE THE UNIT WITHOUT A DUST CONTAINER IN PLACE.
Cleaning and replacing filters
Filters must be cleaned from time to time to remove the fine dust particles that have been collected.
If filters are left uncleaned, it may result in a reduction of suction power. Should this occur, the following procedure should be applied every couple of months.
1.Remove the dust container from the unit by pressing down on the “Press and Lift” button 
.
2.Then press the “Push to Empty” button. The bottom of the container will release. Take off the filter bracket by holding onto the shaft and turning the filter in an
3.To remove the metal filter bracket, simply lift it vertically. The filter bracket can be rinsed in luke warm water. Ensure you let the filter bracket completely dry naturally before replacing.
4.Shake and tap the HEPA filter until all the fine dust particles are removed. After approximately 6 months the HEPA filter should be replaced. The central filter can be washed in warm water. Allow to air dry completely before replacing.
NOTE: Do not use any detergents or boiling water to wash the filter, do not wash the filter in a dishwasher or washing machine.
5.Allow to completely air dry before re- assembling and replacing.
NOTE: Do not dry in a tumble dryer, microwave, oven or near a naked flame. The filter and filter case must be completely dry before replacing into the vacuum.
6.To place the filter back in the dust container, simply place the metal filter bracket directly over the HEPA filter, ensure that the metal filter holder is completely dry before use. Ensure that the grooves on the HEPA filter holder and metal filter bracket fit into place.
7.Simply place the filter unit in the dust container lid and turn the filter unit in a clockwise direction until it is clicked in place. Close the bottom of the container.
8.Place the dust container back in the vacuum cleaner for next use.
KBV580_IB_V3.indd 6 | 10/6/09 3:21:48 PM |
