Using Your Kambrook Arctic Desk Fan
Before First Use
Remove any promotional material from the fan.
IMPORTANT: When unpacking the fan, check to see you have received
all the items listed in the Parts List, before discarding the packaging.
Assembling Your Arctic
Desk Fan
Base Assembly (KFA211 and KFA213 Only)
1.Turn the motor head housing upside down.
2.Locate the bottom of the housing onto the base so that it sits securely into place.
3.Using the 3 supplied base screws, securely fasten the base to the motor head housing.
Fig. 1
NOTE: The KFA210 base is already connected with the motor housing.
Fan Head Assembly
1.Remove the Blade Cap (KFA211 and KFA213 only) from the Motor shaft by turning it clockwise, and then remove the Guard Locking Nut by turning it
2.Thread the Motor shaft through the centre hole of the Rear Grille, placing the Rear Grille into position. Make sure that the carry handle, on the back of the Rear Grille is located above the motor housing. Ensure the Rear Grille is aligned with the locating pins and fix the grille into position by replacing the Guard Locking Nut. Make sure that the Rear Grille has not slipped off the locating pins before tightening. This should be done by hand. Do not force.
NOTE: When positioning the Rear Grille on the Motor shaft, always ensure the carry handle on the grille is positioned in the upright position.
3.Insert the Plastic Blade onto the Motor shaft, and match the pin slots in the blade with the Motor shaft pin.
4.Fix the blade into place by tightening the Blade Cap (KFA211 and KFA213 only) onto the Motor shaft in an anti- clockwise direction. This should be done by hand. Do not force.
NOTE: Ensure the fan blade engages fully onto the shaft. Please note this may require some force to ensure it is fully engaged.
5.Unlatch the Securing Clips on the Front Grille and unscrew the small screw located at the bottom of the front guard.
6.Press together the Front and Rear Grille, and secure by snapping shut the Securing Clips over edges of both grilles. Make sure that the small holes at the bottom of both grilles are aligned. Tighten the Securing Clips by hand.
6
