The use of an extension cord with this appliance is not recommended.
Do not remove plug from power socket until the appliance has been switched off.
Do not remove plug from power socket by pulling flex – always grip plug.
Always unplug appliance when not in use.
Do not allow cord to come in contact with heated surfaces during operation.
Do not run cord under carpeting, throw rugs, runners or the like. Arrange cord away from traffic areas so that it will not be tripped over.
Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that all cord has been removed from the cord storage area.
Do not store appliance while it is still hot.
This appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure they do not play with the appliance.
The appliance must not be located immediately below a
Do not use this appliance in the immediate surrounds of a bath, shower or swimming pool.
If the supply cord is damaged, it must be replaced by a qualified electrical person in order to avoid a hazard.
Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on the appliance.
OPERATING
INSTRUCTIONS
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. All of the controls are located on the top of the heater for easy accessibility and are protected by a plastic control flap.
Neon Indicator
The heater has a power available red light. When the heater has been turned on at the wall, the light will be illuminated indicating power is available to the heater.
Heat Controll Switch
Your heater is fitted with a
0 Off
∞Fan only
ILow heat – 1200W II High heat – 2400W
Check that the heat control switch is set to the off position before plugging the heater into the mains supply.
Fan
The fan setting is used to circulate the room air.
Turn the thermostat clockwise until the maximum temperature setting is reached.
The fan will now circulate the room air.
Heating
Turn the Heat Control Switch to the desired power level (I or II).
Turn the thermostat knob clockwise until the maximum temperature setting is reached.
Thermostat
The thermostat is used to control the room temperature. It acts as a switch and does not vary the amount of heat output from the heater.
Turn the thermostat knob clockwise until the maximum temperature setting is reached.
If the desired room temperature is reached, slowly turn the thermostat knob
The heater will now turn on and off automatically maintaining the room temperature that you have set.
Frost Watch
The frost watch setting is used to prevent the room temperature from falling below approximately 5ºC.
Choose the power level desired on the heat control switch.
Turn the thermostat knob to the * symbol (minimum setting).The heater will now switch on automatically if the room temperature falls below 5ºC.
Tilt Base
The direction of the airflow may be adjusted by tilting the body of the heater up and down. Stopper pins are fitted to limit the angle of adjustment.
CLEANING INSTRUCTIONS
The heater requires regular cleaning to ensure trouble free operation.
1.Unplug the heater from the mains supply before cleaning.
2.Use a damp cloth to clean the exterior of the heater.
3.Use a vacuum cleaner to remove dust and fluff from the inlet and outlet grilles.
4.Ensure the heater is dry before plugging back into the mains supply.
3 | 4 |
