Kambrook KOT600 Important Safeguards for ALL Electrical Appliances, Operating Instructions

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES.

Fully unwind the cord before use.

To protect against electric shock, do not immerse the cord, plug or appliance in water or any other liquid.

Do not let the cord hang over the edge of a table or counter, touch hot surfaces, or become knotted.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

It is recommended to inspect the appliance regularly. Do not use the appliance if the power supply cord, plug and or appliance becomes damaged in anyway. Return the entire appliance to the nearest authorised Kambrook Service Centre for examination, and/or repair.

Any maintenance other than cleaning should be performed at an authorised Kambrook Service Centre.

This appliance is for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors.

The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for

Place the Kambrook Multi-Function Oven on a level, flat surface.

Plug the appliance into a 230/240-volt power outlet.Turn the power on.

Set the Temperature Control to 240°C and the Time Control to 15 minutes.This will eliminate any oil residue that may have been used for packing and shipping.

NOTE: When turned on for the first time, the Kambrook Multi-function Oven may give off vapours for up to 15 minutes. This is due to the protective substances on the heating elements. It is safe, not detrimental to the performance of the Kambrook Multi-function Oven and will dissipate with use.

Allow the oven to cool. Insert the accessories. The Kambrook Multi-function is now ready to use.

OPERATING INSTRUCTIONS

IMPORTANT:The oven will not heat until ALL of the following are activated:

•Temperature is selected

•The Element Control Dial is turned to top, bottom or both elements.

•Timer is activated, or stay-on function is selected

NOTE: To turn off the oven, always turn the Timer to ‘OFF’ position.

The Element Control Dial

The element control dial is able to select the off, top element only, bottom element only or bottom and top elements.

Timer Dial

To activate the timer, turn the dial to the right (clockwise).A bell will sound at the end of the selected time (0-60 minutes).

For setting cooking times less than 30 minutes

–turn the timer dial past the 45 minute mark, then turn back to the desired time, ie for 10 minutes of cooking, turn the dial to 45 minutes then immediately turn back to 10 minutes.

Stay-On Function

To select the Stay On feature turn the selector to the left (counter clockwise).The Oven will remain on until it is manually turned off.

NOTE: Do not leave oven in stay on position for extended periods of time.

Heating Light

The light will illuminate as the oven is heating and will turn off when the oven has reached the selected temperature ie preheated. It will cycle on and off throughout the cooking process.

NOTE: The light always turns off when the element control dial is selected in ‘OFF’ position.

Preheating

For the Grill, Bake and Toast functions best results are achieved by preheating the oven for 5-10 minutes.To preheat the oven, select the desired oven temperature on Temperature Control Dial. Select the Function on the Element Control Dial and select time on the Timer Dial. Once oven is preheated Heating Light will go out. Place food into oven and reset timer to desired cooking time.

CHROME PLATED WIRE RACK

ROASTING AND TOASTING

Position the wire rack on the rack support guide inside the oven, depending on the height of the food or according to recipe directions.

Select the required temperature on the Temperature Control Dial.

Select the ‘MAX’ on the Temperature Control Dial for toasting or select required temperature for roasting.

Select top and bottom elements on the Element Control Dial.

Preheat the oven. Place the food inside the oven and select the desired time on the Timer Dial. The Kambrook Multi-Function Oven will turn off when the timer turns off.

REHEATING

Position the wire rack on the bottom or top rack support guide inside the oven, depending on the height of the pan.

Select bottom only element on the Element Control Dial. Select required temperature on the Temperature Control Dial. Select the desired time on the Timer Dial.

Baking

When baking cakes or biscuits, position the wire rack on the bottom or top rack support guide inside the oven, depending on the height of the pan.

Lower oven temperature to between 120˚C- 180˚C.

Select top and bottom elements on Element Control Dial.

professional advice.

BEFORE FIRST USE

Remove and safely discard any packaging material and promotional labels before using the Kambrook Multi-Function Oven for the first time.

To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the power plug of this appliance.

Always place the wire oven rack into top or bottom Rack Support Guide inside oven in an upward curved position.This provides two rack height positions.

Upward curved position

GRILLING

Position the wire rack in the top rack support guide inside the oven. For grilling use the baking tray with the grill insert.

Select top only element on the Element Control Dial. Select ‘MAX’ setting on the Temperature Control Dial.





KOT600_MINIOVEN_FA.indd 4-5 10/6/08 1:46:37 PM