Kambrook KPH200 manual Operating Instructions, ThermoGuard Overheating Safety Device

Operating Instructions

1.Plug the cord into a 230-240V electrical outlet. Be sure the plug fits tightly, as a loose fit will cause overheating and damage the plug. To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit with your heater when you switch the unit on.

2.There are two ON/OFF switches located at the top left hand side of the rear of the heating unit, with 4 settings.

-OFF

-Low (800W)

-Medium (1200W)

-High (2000W)

When the heater is not in operation, both switches will be in the OFF position.

3.To activate the LOW heat setting, press the switch marked 800W from OFF to ON.

4.To activate the MEDIUM heat, setting, press the switch marked 1200W from OFF to ON.

5.To activate the HIGH heat setting, press both the 800W & 1200W switches from OFF to ON.

6.To turn the heater completely off, return both of the OFF/ON switches to the OFF position.

ThermoGuard Overheating Safety Device

Your heater is fitted with a safety device that switches off the heater in the event of overheating. Should this heater stop working, turn off the heater and inspect the air inlet and outlet for blockages. Wait at least five minutes for the protection system to reset before attempting to restart the heater.

If the heater fails to operate or the safety device switches off again, return the heater to your nearest Kambrook Service Centre for examination or repair.

10

KPH200_IB_Issue1,10.indd 10 4/12/09 2:01 PM