1.Locate the three brackets at the back of the heater. There are two brackets at the left and right hand bottom corners, and one situated at the top of the heater in the centre.
2.As a general safety guide select a suitable location to wall mount the heater, approximately 500mm from any furniture either side of the unit and 500mm from any furniture placed in front of the heater. The heater must be mounted horizontally as per Fig. 1.
3.When selecting a location, make sure the base of the heater is at least 500mm from the floor and the top of the heater is at least 1.5m from the ceiling to ensure there is adequate air flow into the air inlet.
4.Measure out and mark the screw locations. Once you are confident that the screw locations are correct, drill suitable size holes.
5.Take care with inserting the screws into the holes you have made, and then mount the heater onto the screws.
6.Once the heater is mounted on to the wall, screw in the locking screw (the shortest screw) to prevent the heater from being accidentally dislodged from the mounting bracket.
7.Visually inspect the air inlet and outlet to ensure no foreign material is blocking these areas.
CAUTION: Do not mount the heater below curtains and/or other flammable items.
CAUTION: If the heater is intended to be used in a bathroom, the heater is to be installed so that switches and other controls cannot be touched by a person in the bath or shower.
9
KPH200_IB_Issue1,10.indd 9 | 4/12/09 2:01 PM |
