Using Your Convection Panel Heater
Before First Use
Remove your heater from its carton and associated protective wrapping. Unwind the cord to its full length and remove any protective cardboard or foam that may have been used to minimize transportation damage.
How to Operate
The KPH200 can be either wall mounted or used on the floor. Relevant brackets and feet come with the unit. For wall mounting operation, follow instructions under Wall Mounting Instructions.
Floor Use Instructions
1.Place the heater on a firm, level surface in a stable upright position and secure the supplied feet with the screws provided.
2.Visually inspect the air inlet and outlets to ensure no foreign material is blocking these areas.
Securing the Heater Feet
•The heater has two plastic stands or ‘feet’ that come with a set
of screws that you will need to secure at the base of the product. Locate the screws that are positioned at the base of the unit, approximately 5cm from the far left and right sides of the heating unit. Unscrew them, but leave the centre screw in place.
•Clip the plastic feet into the two perforations, located at the base of the unit.
•Line up the screw holes in the plastic stands with those in the base of the heater.
•Turn the heater upright so that the plastic feet are holding up the heating unit.
Wall Mounting Instructions
Please ensure your wall is capable of holding the weight of this heater and that the right screws are used for your wall.
This unit can be mounted on any wall in any room of the home. When selecting a location, decide upon a position that takes advantage of the maximum volume of air.
CAUTION: Before mounting the heater to the wall please ensure that all three attachment points are secure in either timber or concrete. Do NOT secure directly into plaster. Please contact a tradesman if you are unsure.Please see the Fig. 1 which illustrates the points of contact. Ensure that the heater is at least 500mm from the floor and corners of the wall.
Fig. 1
8
KPH200_IB_Issue1,10.indd 8 | 4/12/09 2:01 PM |
