KAMERA WERK DRESDEN GmbH

⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯

Attaching the Camera Strap

Thread the camera strap in the lug (8).

Inserting the Batteries

NOBLEX PRO cameras require 4 batteries AAA (RO3/UM4/LR) 1,5V. Please use high-quality alkaline batteries, of course, with items ‚Photo/Audio‘, ‚Photo‘ or ‚Power‘. When inserting the batteries follow these instructions:

1.Open the battery compartment cover (24) by pressing the upper half of the cover slightly and push it upwards.

2.Open up the battery compartment cover (24).

3.Insert the new batteries. Pay attention to the right polarity and position of the strips for removing the batteries.

4.Lift the battery compartment cover (24) down.

5.Close the cover by pressing the lower half of the cover slightly and push it downwards at the same time until it is engaged.

Please note

Never use batteries of different types and do not mix old batteries with new ones. Do not use rechargeable batteries. If you do not use your camera for an extended time, remove the batteries for this time.

Inserting and removing the film

NOBLEX PRO cameras require 120 roll film. To insert and change the film please follow these instructions:

Inserting the film (NOBLEX PRO 150)

1.Turn the camera off at the ON/OFF switch (10).

2.Advance the winding disk (5) until the counter (5a) reaches position »5«. (If necessary, press the shutter release button (4) to advance to the position »5«.)

3.Unlock the camera back (9) and open it.

4.Insert the film spool into the left-hand spring- loaded compartment (14).

5.Insert the empty film spool into the right-hand compartment (18). The spool must engage in the

upper catch (20).

6.Thread the tongue of the paper lead into the take-up spool.

7.Turn the winding disk (5) until the double arrow on the protective paper of the film is opposite the red dot on the camera film guide (16). pay attention to insure a tight winding of the film.

8.Close the camera back and lock it (9).

9.Press the start button (5b). The counter is released with that. Remark: At older models the start key (5b) isn't available yet. In this case the shutter release button (4) has to be pushed.

10.Advance the winding disk (5) in the direction of the arrow until it stops. The film counter should be at the number 1. To take a picture turn the camera on at the ON/OFF switch (10) and press the shutter release button (4).

⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯

Page 6 of 15