KAMERA WERK DRESDEN GmbH

⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯

Filters and Close-up Lenses

As accessories for NOBLEX cameras we offer a wide range of filters and close-up lenses. NOBLEX filters an close-up lenses are specially designed with a magnetic ring on the back surface of the filter/close-up lenses. They can thus directly be fixed to the lens. For inserting the filter or a close-up lens follow these instructions:

1.Turn the camera off at the ON/OFF switch (10).

2.Push the double exposure button (6) to position »M«.

3.Press the shutter release button (4) and hold it pressed.

4.Turn the lens drum anticlockwise until it reaches a stop.

5.Release the shutter release button (4).

6.Put the camera on its back.

7.Pick up the filter or the close-up lens by the hole of the filter ring using a pair of tweezers and insert it through the shutter slit. Place the filter onto the lens. The filter is magnetically held onto the front of the lens.

8.Turn the lens drum back until it is engaged.

9.Push the double exposure button (6) back to single exposure, if desired.

When removing the filter or the close-up lens follow the same procedure.

Please note

To step 5: If you turn the drum clockwise the film is exposed and you lose one picture. Please be very careful when changing filters/close-up lenses in order to avoid damage to the lens caused by the tweezers.

The Slow Exposure Module

The module for slow exposures offers you the opportunity to work comfortably with these NOBLEX PRO cameras designed for the slow exposure module in the slow speed range. The necessary power is supplied by the batteries of the camera.

Attaching to NOBLEX PRO

To attach the module to your camera please follow these instructions:

1.Remove the protective cap by turning the fastening knob (701) clockwise.

2.Turn the camera off at the ON/OFF switch (10).

3.Turn the control ring (702) of the module until both white dots face each other.

4.Attach the slow exposure module to the left-hand camera bottom so that the guide pins (703) mesh with the inter-face (11) in the camera bottom. At the same time the white dots of camera and slow speed module must face each other.

5.Turn the fastening knob (701) until the module is tightly connected with the NOBLEX camera.

To remove the module tram your camera please follow these instructions:

704

703

702

701

1.Turn the camera off at the ON/OFF switch (10).

2.Turn the control ring (702) of the module until both white dots face each other.

⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯

Page 9 of 15