Karcher G 2600 PC manual Troubleshooting, English

Models: G 2600 PC

1 46
Download 46 pages 45.97 Kb
Page 14
Image 14
TROUBLESHOOTING

TROUBLESHOOTING

CAUTION

Remove the spark plug cable to prevent ac- cidental ignition of the engine before making any repair.

Symptom

POSSIBLE CAUSE

SOLUTION

Engine will not start

No gasoline

Fill gas tank

 

Choke is not in the correct position.

Slide choke lever out to closed position.

 

Water pressure built up in the ma-

Squeeze the trigger to release the pressure.

 

chine.

 

 

For additional engine problems refer to the engine manual.

Unit does not reach

Diameter of garden hose is too

Replace with a 5/8 inch or larger garden

high pressure.

small.

hose.

 

Water supply is restricted.

Check garden hose for kinks, leaks and

 

 

blockage.

 

Not enough inlet water supply.

Turn water on full force. Check garden hose

 

 

for kinks, leaks or blockage.

 

Water inlet filter is clogged.

Remove filter and rinse out in warm water.

 

Black detergent nozzle is attached.

Remove black detergent nozzle and attach

 

 

high pressure nozzle

Output pressure

Not enough inlet water supply.

Turn water on full force. Check garden hose

varies high and low.

 

for kinks, leaks or blockage.

 

Pump is sucking air.

Check that hoses and fittings are air tight.

 

 

Turn off machine and purge pump by

 

 

squeezing trigger gun until a steady flow of

 

 

water emerges through the nozzle.

 

Water inlet filter is clogged.

Remove filter and rinse out in warm water.

 

Spray nozzle is obstructed.

Blow out or remove debris with a fine needle.

 

Calcified gun, hose or spray wand.

Run distilled vinegar through detergent suc-

 

 

tion tube.

No detergent.

Detergent suction tube not properly

Check connection.

 

connected to the machine.

 

 

Detergent is too thick.

Dilute detergent, for best results use

 

 

Kärcher® detergent.

 

Filter on detergent suction tube is

Run warm water through filter to remove

 

clogged.

debris.

 

Damaged or clogged detergent suc-

Remove obstruction or replace detergent

 

tion tube.

suction tube.

 

A high pressure nozzle is attached.

Replace with black detergent nozzle.

 

Metering valve closed.

Open metering valve.

 

 

 

 

Spray nozzle is obstructed.

Blow out or remove debris with fine needle.

 

 

 

Garden hose con-

Loose fittings.

Check and replace if necessary.

nection leaks.

Missing/worn rubber washer.

Insert new washer.

 

Spray wand leaks.

Spray wand not properly attached.

Turn the swivel nut of the gun clockwise until

 

 

connection is tight.

 

 

 

 

Broken o-ring or plastic insert.

Call Customer Support

14 English

Page 14
Image 14
Karcher G 2600 PC manual Troubleshooting, English