Karcher K 5.70 M manual Operation, Scope of delivery, Description of the Appliance, Before Startup

Operation

Scope of delivery

The scope of delivery of your appliance is il- lustrated on the packaging. Check the con- tents of the appliance for completeness when unpacking.

In the event of missing accessories or any transport damage, please contact your dealer.

Description of the Appliance

Illustrations on Page 2

1Coupling element for water connection

2High pressure connection

3ON/OFF switch for appliance

4Detergent Tank

5Storage for trigger gun

6Dosage regulator for detergent

7Suction hose for detergent

8Transport handle

9Storage for accessories

10Power cable with plug

11Connection for water supply with filter

12Trigger gun

13Lock trigger gun

14High pressure hose

15Spray lance with pressure regulation (Vario Power)

16Spray lance with Dirtblaster

17Washing brush

Special accessories

Special accessories expand the possibilities of using your appliance. Please contact your KÄRCHER dealer for further information.

Before Startup

Illustration

Mount loose parts delivered with appliance prior to start-up.

Illustration

Push the high pressure hose into the trigger gun until it locks audibly.

Note: Make sure the connection nipple is aligned correctly.

Check the secure connection by pulling on the high-pressure hose.

Water supply

￿Warning

According to the applicable regula- tions, the appliance must never be used on the drinking water supply without a system separator. Use a suitable system separator manufactured by KÄRCHER; or, as an alternative, a system separator as per EN 12729 Type BA. Water flowing through a system separator is con- sidered non-drinkable.

Caution

Always connect the system separator tothe water supply, never directly to the appli- ance!

Note: Impurities in the water can damage the high-pressure pump and accessories. For protection, the use of the KÄRCHER water filter (optional accessory, order no. 4.730-059) is recommended.

Water supply from mains

Observe regulations of water supplier.

For connection values, see type plate/tech- nical data.

Use a fibre-reinforced water hose (not included) with a standard coupling. (Minimum diameter 1/2 inch (13 mm), minimum length 7.5 m).

Screw the coupling element (supplied) to the water connection on the appli- ance.

Push the water supply hose onto the coupling unit, then connect it to the wa- ter supply.

Start up

Caution

Dry runs lasting longer than two minutes lead to damages to the high pressure pump. If the appliance does not build up pressure within two minutes, switch it off and proceed as instructed in the Chapter "Troubleshooting".

6English