Figure 4-6. Disassembling the drive shaft

 

 

Figure 4-7. Rear panel access

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Remove eight (8) screws to remove rear panel

Bearings

(2 total)

Grease fitting

(1 per

bearing)

Blower belt

Blower motor

E. Blower Belt

1.Remove the six screws shown in Figure 4-7. Then, remove the rear panel from the oven.

2.Check the blower belt for the proper 1/4(6mm) deflec- tion at the center, and for cracking or excessive wear.

See Figure 4-7. Overtightening the belt will cause premature bearing failure and possible vibrations. A loose belt may also cause vibrations.

3.If necessary, adjust the tension of the belt by loosening

the four motor mounting bolts. Reposition the motor as neccessary until the correct 1/4(6mm) deflection is reached, then tighten the bolts.

Loosen four (4) screws to adjust motor position and belt tension

IV. MAINTENANCE - EVERY 6 MONTHS

A.Check that the oven is cool and the power is discon- nected, as described in the warning at the beginning of this Section.

B.Check for excessive wear on the conveyor drive motor

brushes. The brushes should be replaced if they have worn to less than 1/4(6mm) in length. Be sure to replace the brushes in exactly the same position.

C.For gas ovens, inspect and clean the burner nozzle and the spark electrode assembly.

D.Check the conveyor drive shaft bushings and spacers. Replace the components if they are worn.

23

Page 27
Image 27
Karcher PS640G installation manual IV. Maintenance Every 6 Months, Blower Belt