_____________________________________________________________
OLYMPIA UHF antennas | AOI 65 | 212340 |
Suitable for | AON 65 | 212344 |
AOP 65 | 212348 | |
|
__________________________________________________________________________________
General safety instructions
Please read the following safety instructions carefully and thoroughly before you start installing the antenna, and keep observing them during the installation.
The installation of the antenna demands a high degree of responsibility for yourself and other people. For this reason, the installation must be executed by an electrician (expert on his/her trade). In order to assist you, some important safety instructions have been compiled in the following. However, these instruc- tions are not exhaustive, as we are not aware of the local conditions.
1.Do not use the antenne for purposes other than intended by the manufacturer.
2.Only use the components as prescribed by the manufacturer and do not modify them.
3.ATTENTION! DANGER TO LIFE!
Do never mount an antenna under power supply lines! Touching power supply lines with parts of your body, with antenna parts or tools may cause an electrical shock or serious burns.
4.When selecting the antenna site, you must consider the structural characteristics of the building. Installation on the edge of rooftops or buildings and on cylindrical structures could lead to increased wind loads and vibration stress according to DIN 1055, part 4, or DIN 4131.
AOI 65
AON 65
AOP 65
5.Do not install the antenna on buildings with easily inflammable materials as rooftop, such as straw, reed or similar materials.
6.Only step on firm, dry rooftops and protect yourself against falling down.
7.Ladders, scaffoldings, safety belts etc. must be in good order.
8.
9.Mind that the technical values (e.g. wind load) of the antenna mast are not exceeded. Refer to the manufacturer if you do not know these values. Find an overview of the masts offered by Kathrein on the last page.
10.Mount the antenna mast on solid ground only (walls, concrete, rafters) using the clamps, dowels and screws recommended by the manufacturer.
11.Immediately leave the roof in case of a thunderstorm!
12.Ground the antenna installation according to EN
Notice:
The OLYMPIA UHF antennas were designed solely for the limited purpose of receiving terrestrial TV signals and as indoor antennas. Under the terms of DIN 4131, an antenna is reckoned an indoor antenna if the mast length does not exceed 6 metres and if the torque needed for screwing the antenna is at 1,650 Nm at maximum.
936.2595/B/1104/1.4e
