SAFETY
This device was built and tested in accordance with the enclosed EU certificate of conformity and left the factory in a condition fullfilling all requisite safety regulations. To ensure that this condition is maintained and to ensure
Symbols used on Kathrein devices and in manuals:
Follow operating instructions
Information on the weight of devices with a mass > 18 kg
Earth conductor connection. Ground connection point caution!
Hazardous voltage on physical contact
Warning hot surfaces
Electrostatic sensitive components requiring special handling
Attention Earthing!
1.The device is only allowed to be operated in the operational status and in systems as stated by the manufacturer (attention is to be paid to adequate ventilation). The following applies: IP protection class 2X, degree of soiling 2, overvoltage category 2, only for use indoors, operation at up to 2000 m above sea level. Outdoor use is only permissible if the measuring instrument is protected from rain and humidity. The device is only allowed to be operated on supply grids that are protected with fuses with a maximum rating of 16 A. If not otherwise stated in the data sheet, a tolerance of ± 10 % applies to the nominal mains voltage and a tolerance of ± 5 % to the nominal mains frequency.
2.In case of measurements in circuits with voltages Ueff > 30 V, precautions must be taken using suitable measures to ensure that any hazard is excluded (e.g. suitable measuring equipment, fuse protection, current limiting, isolation, insulation, etc.).
3.If a device is installed in a fixed position, the connection between the
4.If devices in a fixed installation do not have a fuse, circuit breaker or similar protective de- vice, the supply circuit must be fused so that device and user are adequately protected.
4
