Kathrein MSK 200/S2 user manual Operation, Initial START-UP, Setting UP the Device, SET-UP Options

OPERATION

INITIAL START-UP

Prior to operating for the first time, please take the T 8.0 A fuse out of the packaging and fit it into the provided fuse holder.

After insertion of the protector, the device muss be operated or charged on the power supply unit for ap- proximately two hours. Subsequently, the device must be completely discharged during battery-powered operation (until the device switches off by itself). Battery charge level can only be correctly displayed if the device has been fully charged and then fully discharged.

The fuse prevents the device being switched on unintentionally during transport.

Caution!

Please remove this fuse again before shipping the device!

Remove the AC power supply unit (100V ... 250V) supplied from the packaging and connect the device to the mains using the power supply. The Li ion rechargeable battery in the device will now be charged. The green light emitting diode indicates use of an external power source. You can check the charge state of the rechargeable battery by pressing the “Test“ key.

Caution!

See also “Charging indicator” and “DC supply socket” in the section “Interfaces”

SETTING UP THE DEVICE

When setting up the device pay attention to adequate ventilation!

To avoid a build-up of heat, the openings for the fan and the ventilation holes must always be kept clear. Set up the device as shown in the figure.

SET-UP OPTIONS

7