Kawasaki 691225 instruction manual Assemble Rotary Tool Stand, For Model, Types of Accessories

ASSEMBLE ROTARY TOOL STAND

FOR MODEL 840169:

The rotary tool stand is used to hold the rotary tool while using the flexible shaft.

1.Insert the bottom end of the tool holder into the matching slots in the base of the stand.

Rotate the tool holder to position the tool clamp to the right-hand side.

2. Rotate tool holder 90° clockwise to lock it to the base.

3. Pull out on the tool holder clamp lever to open the tool holder clamp.

4. Insert tool into the clamp from the top.

Make sure the tool is fully inserted to the ridge in the tool body.

5.Push the tool holder clamp lever toward the tool until it snaps into the place and firmly holds the tool in place.

For your convenience, accessories can be stored in the holes provided in the base of the stand.

When the tool is left installed in the stand with the flexible shaft installed, hang the collet end of the flexible shaft in the slotted holder at the rear of the stand.

TYPES OF ACCESSORIES

YOUR ROTARY TOOL MAY BE USED WITH THE FOLLOWING ACCESSORIES:

Sanding Bands: These small drum sanders help you shape and smooth surfaces in tight places. Replace bands when they become worn. Bands come in fine grades for finish and delicate work and coarse grades for heavier work. Sanding bands work best at lower speeds. Experiment with scrap material before working on an actual project. To use a sanding band, loosen the screw in the shank, slip the band onto the shank, then tighten the screw to secure the band.

15°

Brushes: Wire brushes are useful for cleaning
and polishing metal, while bristle brushes are
suitable for cleaning softer surfaces. As with all	RIGHT
rotary tool accessories, you should let the
speed do the work without applying excessive
force. Use the bristle tips only without mashing
the brush against the work piece as shown in
the top part of the illustration on the right.	WRONG

NEVER RUN BRUSHES AT SPEEDS ABOVE 15,000 RPM.

The brush could eject bristles at high speed which could become embedded in your skin or which could cause other serious injury.

Drill bits: High-speed steel drill bits are suitable for most drilling applications in wood, plastic, and thin metal. For ceramics, drywall, or other specialized applications, you will need to purchase an appropri- ate drill bit.

Cutting wheels: To prepare a cutting wheel for use, remove the screw in the center of the shank, mount the wheel, and replace the screw.

17 18