ROCKER SWITCH AND DIRECTION OF ROTATION
• To rotate the Impact Wrench
in a clockwise direction, press
the lower portion of the
Rocker Switch.
• To rotate the Impact Wrench
in a counter-clockwise
direction, press the upper
portion of the Rocker Switch.
INSTALLING / REMOVING SOCKET
When installing a socket,
align the holes in the side
of the socket with the dent
pin. Press the socket on until
the dent pin engages in the hole.
To remove a socket, depress
the dent pin through the hole
using a small pointed object, and
pull the socket off.
When removing the socket or bit
from the tool, avoid contact with
skin and use proper protective
gloves when grasping the socket,
bit or accessory. Accessories may
be hot after prolonged use.
MAINTENANCE AND CLEANING
Always UNPLUG the Impact Wrench from power source
before attempting cleaning or maintenance.
This Impact Wrench is lubricated before it leaves the
factory. This lubrication should last for the life of the tool. No further
lubrication is required.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get
inside the casing. Never immerse any part of the tool in a liquid. Always keep the
ventilation openings clear.
Brushes will wear with use and should be inspected periodically by qualified
personnel. Unscrew the plastic caps on the sides of the motor housings to inspect
the spring and brush assembly. If the brushes are worn down to the line closest to
the spring, replace them immediately.
Regularly clean the ventilation slots in your tool and charger using only a soft
brush or dry cloth.
Never open the Impact Wrench case. Do not attempt to repair the Impact Wrench
yourself. Opening this tool will void your warranty.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.
If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may experi-
ence a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord (see table below).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING CONDUCTOR SIZE IN A.W.G
AMPERE 10FT. 25FT. 50FT. 100FT.
3-6 18 18 18 18
6-8 18 18 18 16
8-10 18 18 18 14
10-12 16 16 14 14
12-16 14 12 12 -
16-20 12 12 12 -
9
ROCKER
SWITCH
CLOCKWISE
COUNTER-CLOCKWISE