9
Catalyst 6500 Series Switch and Cisco7600 Series Router CMM Installationand Verification Note
78-14107-07
Required Tools
Required Tools
Warning
Only trained andqualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
These tools are required to remove and replace the CMM and port adapters:
•Flat-blade screwdriver (for CMM)
•Number 1 Phillips screwdriver (for the screws and standoffs)
•Antistatic mat or foam pad
•Yourown ESD-prevention equipment or the disposable grounding wrist strap that is included with
all upgrade kits, field-replaceable units (FRUs), and spares
Whenever you handle a module, always use a wrist strap or other grounding device to prevent
electrostaticdischarge (ESD). For information on preventing ESD, refer to the “Preventing ESD” section
of the Regulatory Compliance and Safety Informationpublication.
Installing and Removing the CMM
This section describes the procedures for installing and removing the CMM:
•Installing the CMM, page 9
•Removing the CMM, page 16
Installing the CMM
This section describes how to install the CMM into the Catalyst 6500 series switch or the Cisco 7600
series router.
Note All modules, including the supervisor engine (if you have redundant supervisor engines), support hot
swapping. You can add, replace, or remove modules without interrupting the system power or causing
other software or interfaces to shut down. For more information about hot-swapping modules, refer to
the Catalyst 6500 Series Switch Module Installation Guide.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94