3
Catalyst 6500 Series Switch and Cisco7600 Series Router CMM Installationand Verification Note
78-14107-07
Front Panel Descriptions
Port adapter slots—Figure 1 shows the E1 port adapter in the left and middle slots, with a blank filler
plate in the right slot.
REAR MODULE STATUS LED—Table2 describes the REAR MODULE STATUS LED operation.
Note For information on the supervisor engine LEDs, refer to the Catalyst 6500 Series Switch Supervisor
Engine Guide at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/6000hw/supe_gd/index.htm
Figure 1 CMM Front Panel Features
Table1 CMM STATUS LED
Color Description
Off The module is waiting for the supervisor engine to grant power.
The module is not online.
The module is not receiving power, which could be caused by the following:
Power is not available to the module.
Module temperature is over the limit1.
1. Enter the show environment temperaturemod command to display the temperature of each of the four sensors on the
module.
Red The module is released from reset by the supervisor engine and is booting.
If the boot code fails to execute, the LED stays red after power up.
Orange The module is initializing hardware or communicating with the supervisor
engine.
A fault occurred during the initialization sequence.
If the module fails to downloadits Field Programmable Gate Arrays (FPGAs)
on startup, it continues initializing and is granted module online status from
the supervisor engine, but the LED stays orange.
If the module is not granted module online status from the supervisor engine,
the LED stays orange. This problem could be caused by the supervisor engine
detecting a failure in an external loopback test that it issued to the module.
Green The module is operational; the supervisor engine has granted module online
status.
STATUS
WS-SVC-CMM
0
WS-SVC-CMM-6E1 WS-SVC-CMM-6E1
1234 5
Communication Media Module
REAR MDL
STATUS
68447
6-Port E1 Interface Port Adapter. 6-Port E1 Interface Port Adapter.
REAR MODULE STATUS LEDSTATUS LED
Interface Module slots
012345