Installing and Removing the CMM

To install the CMM into the Catalyst 6500 series switch or the Cisco 7600 series router, perform these steps:

Step 1 Make sure that you take the necessary precautions to prevent ESD damage.

Step 2 Choose a slot for the CMM.

Step 3 Verify that there is enough clearance to accommodate any interface equipment that you will connect directly to the module ports. If possible, place modules between empty slots that contain only module filler plates.

Step 4 Verify that the captive installation screws are tightened on all modules that are installed in the chassis.

This action ensures that the EMI gaskets on all modules are fully compressed to maximize the opening space for the replacement module.

Note If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent modules toward the open slot, reducing the opening size and making it difficult to install the replacement module.

Step 5 Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. (To remove a module, refer to the “Removing the CMM” section on page 16 .)

Step 6 Fully open both ejector levers on the new or replacement module. (See Figure 5.)

Step 7 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the following sets of substeps:

Horizontal slots

a.Position the module in the slot. Make sure that you align the sides of the module carrier with the slot guides on each side of the slot. (See Figure 5.)

a.Carefully slide the module into the slot until the EMI gasket along the top edge of the module makes contact with the module in the slot above it and both ejector levers have closed to approximately 45 degrees with respect to the module faceplate. (See Figure 6.)

Catalyst 6500 Series Switch and Cisco 7600 Series Router CMM Installation and Verification Note

10

78-14107-07

 

 

Page 10
Image 10
Cisco Systems WS-SVC-CMM manual Horizontal slots

WS-SVC-CMM specifications

Cisco Systems WS-SVC-CMM, also known as the Cisco Services Control Module, is a high-performance network appliance designed to enhance the capabilities of Cisco routers and integrate a variety of advanced services into existing infrastructures. This revolutionary module caters to enterprises yearning for reliability, scalability, and performance improvements in their network environments.

One of the primary features of the WS-SVC-CMM is its remarkable ability to deliver service integration, enabling organizations to incorporate services such as firewall protection, intrusion prevention, and content filtering directly into their existing Cisco router framework. This integration streamlines operations and reduces the need for multiple devices, leading to lower total cost of ownership.

The WS-SVC-CMM supports a broad array of technologies that empower businesses to optimize their networks. With built-in Cisco Secure Services and Intelligent Network services, organizations can efficiently manage security policies and streamline operations across various network segments. This module supports Virtual Routing and Forwarding (VRF), allowing for flexible traffic management and network segmentation without compromising performance.

Moreover, its architecture is designed for scalability, ensuring that businesses can adapt as their operational needs evolve. The WS-SVC-CMM can accommodate growth seamlessly, handling increased throughput and expanded services without the need for significant hardware upgrades. High availability and redundancy are also key aspects, which means organizations can depend on constant uptime and reliability.

In addition to security and scalability, the WS-SVC-CMM boasts exceptional performance characteristics. With advanced load balancing capabilities and enhanced QoS (Quality of Service) features, this module can prioritize critical applications and manage bandwidth effectively, providing a superior user experience.

User-friendly management capabilities through Cisco's Integrated Management Framework enable network administrators to configure, monitor, and troubleshoot services conveniently. This centralized approach reduces complexity and increases agility, making it easier to respond to changes within the network.

Overall, Cisco Systems WS-SVC-CMM is a robust and versatile solution tailored for businesses looking to enhance their network functionalities. With an emphasis on seamless service integration, high availability, performance scalability, and comprehensive management, this service control module stands out as a strategic investment for enterprises committed to advancing their digital ecosystems.