Cisco Systems WS-SVC-CMM

Catalyst 6500 Series Switch and Cisco7600 Series Router CMM Installationand Verification Note

78-14107-07

Requirements

Figure 4 Ad-hoc Conferencing and Transcoding Port Adapter Front Panel Features

Requirements

These sections describe the hardware and software requirements:

•Hardware Requirements, page 6

•Software Requirements, page 7

Hardware Requirements

The hardware requirements for the CMM are as follows:

•Catalyst 6500 series switch.

•Cisco 7600 series router.

•ASupervisor Engine 1, Supervisor Engine 2, or Supervisor Engine 720—The supervisor engine can have

an MSFC, MSFC2, or MSFC3, but the CMM does not require one for conﬁguration or operation.

•Port adapters—Youcan install up to three T1, E1, or FXS port adapters into slots 1 through 3 on the

CMM base module.

You can install up to four ACT port adapters into the CMM base module. (The internally located

slot 4 is reserved for the ACT port adapter.)

Note You cannot mix T1 port adapters with E1 port adapters, but any other combination of port

adapters is supported.

•CMM module blank filler plate (WS-SVC-CMM-BLANK) for unused port adapter slots.

Table5 Ad-hoc Conferencing and Transcoding Port Adapter STATUS LED

Color Description

Green Port adapter is up and operational.

Red Port adapter is shut down.

Off Port adapter is not located by the system.

WS-SVC-CMM-ACT

Ad-hoc Conferencing and Transcoding Port Adapter

99302