Installing and Removing the CMM
Figure 6 Clearing the EMI Gasket in a Horizontal Slot Chassis
|
| |
| 1 | CONSOLE |
|
| |
|
| PORT |
| CONSOLE | MODE |
| SUPERVISOR2 |
|
|
| |
| 2 | CONSOLE |
|
| |
|
| PORT |
| CONSOLE | MODE |
| SUPERVISOR2 |
|
| 3 |
|
Press down |
| |
| 4 |
|
FAN |
| |
STATUS | 5 |
|
| 24 PORT 100FX |
|
| 6 |
|
| 3 |
|
4 | 4 |
|
|
| |
| Switch | Load |
|
| 100% |
|
|
|
| PORT 1 | PORT 2 |
PCMCIA | EJECT |
|
|
| 1% |
|
|
| Switch | Load |
|
| 100% |
|
|
|
| PORT 1 | PORT 2 |
PCMCIA | EJECT |
|
|
| 1% |
|
|
Press down
SELECT
NEXT
| |
5 | 5 |
| |
| SWITCH |
| FABIRD MDL |
6 | 6 |
|
STATUS | ACTIVE |
1 mm Gap between the module EMI gasket and the module above it
58570
b.Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a small (0.040 inch [1 mm]) gap between the EMI gasket and the module above it. (See Figure 6.)
Caution Pressing down too firmly on the levers will bend and damage them.
c.While pressing down, simultaneously close the left and right ejector levers to fully seat the module in the backplane connector. The ejector levers are fully closed when they are flush with the module faceplate. (See Figure 7.)
Catalyst 6500 Series Switch and Cisco 7600 Series Router CMM Installation and Verification Note
12 |
| |
|
