Cisco Systems WS-SVC-CMM

Catalyst 6500 Series Switch and Cisco7600 Series Router CMM Installationand Verification Note

78-14107-07

Contents

This publication contains these sections:

•Front Panel Descriptions, page 2

•Requirements, page 6

•Safety Overview, page7

•Required Tools, page9

•Installing and Removing the CMM, page 9

•Removing and Replacing Port Adapters, page 18

•Verifying the Installation, page24

•RJ-45 Port Connector and Cabling Specifications, page 24

•RJ-21 Port Connector and Cabling Specifications, page 26

•Accessing the Port Adapter Ports, page 27

•Configuring the Port Adapter Ports, page 28

•Configuring the Port Adapter Clock Source, page 28

•Disaster Recovery for CMM Software Upgrades, page 29

•Regulatory Standards Compliance, page 31

•Related Documentation, page 31

•Obtaining Documentation, page 32

•Documentation Feedback, page 33

•Cisco Product Security Overview, page33

•Obtaining Technical Assistance, page 34

•Obtaining Additional Publications and Information, page 35

Front Panel Descriptions

These sections describe the front panel features of the CMM and the port adapters:

•CMM, page 2

•6-Port T1 and E1 Port Adapters, page 4

•24-Port FXS Port Adapter, page 5

•Ad-Hoc Conferencing and Transcoding Port Adapter, page5

CMM

The front panel features of the CMM are as follows:

•STATUS LED—When the CMM powers up, it initializes various hardware components and

communicates with the supervisor engine. The STATUS LED shows the dialog with the supervisor

engine and the results of the initialization. During the normal initialization sequence, the STATUS

LED changes from off to red, to orange, and then to green. Table 1 describes the STATUS LED

operation.