REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK: 1. Press both release
buttons on either side of the Cordless
When the battery pack requires recharging, a
CHARGING BATTERY PACK
Reciprocating Saw to release the battery pack.
2. Pull battery pack free of Cordless Reciprocating Saw.
ATTACH BATTERY PACK: |
|
1. Align the raised portion of the battery pack |
|
with the groove in the battery compartment | RELEASE BUTTON |
of the Cordless Reciprocating Saw. |
|
2.Press the battery pack into place. Make sure the latches are securely fastened. Do not use the Cordless Reciprocating Saw if the battery pack is not seated properly.
CHARGER
CHARGE BATTERY PACK:
1.Make sure the trigger on the Cordless
Reciprocating Saw
is in the “OFF” position and remove the battery pack from the Cordless Reciprocating Saw.
2. Plug 120V AC Adapter into household outlet
and into side of battery charger. Insert battery pack into battery charger.
When the battery is placed in the charger, the red LED indicator light will remain on.
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
3.When fully charged, reattach battery pack onto Cordless Reciprocating Saw, making certain latches fasten securely. Cordless Reciprocating Saw will not operate properly if the battery pack is not seated properly.
ASSEMBLY
Be aware that this tool is always in an operating condition because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing blades.
11 | 12 |