Kawasaki 840138-1HR Charge Battery Pack, Operating the Worklight, Operating the on / OFF Switch

	CHARGING BATTERY PACK
CHARGE BATTERY PACK:		BATTERY PACK
1.	Plug the charger into
	the nearest 120 volt
	electrical outlet.
2.	Make sure the trigger
	on the Cordless Worklight	LED
	is in the “OFF” position
		LIGHT
	and remove the battery
	pack from the Worklight.
3.	Insert the battery pack into
	the charger. Be sure that the	BATTERY
	battery pack is fully seated

OPERATING THE WORKLIGHT

Parts of this Worklight heat up almost immediately when in use. To avoid burns, use caution when handling light bulb and metal reflector. Never change a hot light bulb. Bulb must be cool to the touch before attempting to remove or replace it.

OPERATING THE ON / OFF SWITCH

Press the “ON/OFF” switch to turn the worklight “ON” and “OFF”.

ADJUSTING THE WORKLIGHT BEAM

in the charger. CHARGER

Do not force.

4.The red indicator light should come “ON” indicating that the battery pack is in a “Fast Charge” mode. If the green indicator light comes “ON”, then the battery is already fully charged.

5.After approximately one hour of charging, the red indicator light should go “OFF” and the green light should come “ON” indicating that the battery is fully charged and the charger is now in a “Trickle Charge” mode.

6.The battery can be left in a “Trickle Charge” mode until ready to use.

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

Hold the handle of the Worklight securely in one hand. With the other hand, swivel the head of the Worklight counter-clockwise until it is at the angle you desire. Swivel the head of the Worklight clockwise to return it to its original position.

UP

DOWN

When using your Worklight continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the battery pack cools down, the red light will glow continuously to indicate fast charging mode, 1-hour charge time.

This will occur when continuous use of your Worklight causes the battery pack to become hot. It does not occur under normal circumstances.

REPLACING THE LIGHT BULB

This Worklight uses a Krypton 18V, 0.3A light bulb. Use of any other kind of light bulb may cause damage or injury.

Parts of this worklight heat up almost immediately when in use. To avoid burns, use caution when handling light bulb and metal reflector. Never change a hot light bulb. Bulb must be cool to the touch before attempting to remove or replace it.

9 10