Lenovo 2518X01 System board, Charge the battery pack, Enter the supervisor password, Installed

Table 2. Numeric error codes (continued)

Symptom or error	FRU or action, in sequence
0188	System board.
Invalid RFID Serialization Information Area.
0189	System board.
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190	1.	Charge the battery pack.
Critical low-battery error	2.	Battery pack.
0191	1.	Run BIOS Setup Utility, and then save current
System Security—Invalid Remote Change requested.		setting by pressing F10.
	2.	System board.
0192	System board.
System Security— Embedded Security hardware tamper
detected.
0193	Enter the supervisor password.
RF antenna has been removed
0194	Enter the supervisor password.
The computer has been carried through a security gate
0195	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware tamper detected		password, and select “Password ➙ Security Chip
		➙ Clear Security Chip” to clear this error.
	2.	Security chip.
	3.	System board.
0196	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware removed		password, and select “Password ➙ Security Chip
		➙ Clear Security Chip ” to clear this error.
	2.	Security chip.
	3.	System board.
0197	The remote configuration for the security chip has
Invalid remote change requested.	failed. Confirm the operation and try again.
0199	1.	Run BIOS Setup Utility, and then save the current
System Security— Security password retry count		setting by pressing F10.
exceeded.	2.	System board.
01C8	1.	Remove either a Mini-PCI Card or a modem
Two or more modem devices are found. Remove all but		daughter card. Otherwise, press Esc to ignore
one of them. Press <Esc> to continue.		the warning message.
	2.	System board.
01C9	1.	Remove either a Mini PCI Ethernet card or an
Two or more Ethernet devices are found. Remove all but		Ethernet daughter card. Otherwise, press Esc to
one of them. Press <Esc> to continue.		ignore the warning message.
	2.	System board.
01C9	1.	Remove the Ethernet device that you installed; or
More than one Ethernet devices are found. Remove one		press Esc to ignore the warning message.
of them. Press <Esc> to continue.	2.	System board.
01CA	1.	Remove the wireless LAN device that you
More than one Wireless LAN devices are found. Remove		installed.
one of them.	2.	System board.
0200	1.	Reseat the hard disk drive.
Hard disk error—The hard disk is not working.	2.	Load Setup Defaults in BIOS Setup Utility.
	3.	Hard disk drive.
	4.	System board.

62ThinkPad T410 and T410i Hardware Maintenance Manual