ONE HOUR CHARGER #690507
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
When the battery pack requires recharging, a 1 hour charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.
CHARGING BATTERY PACK USING ONE HOUR CHARGER #690507
4.After approximately one hour of charging, the red indicator light should go “OFF” and the green light should come “ON”. The green light indicates that the battery is fully charged.
5.When fully charged, reattach battery pack onto Cordless Waxer/Polisher, making certain latches fasten securely. Cordless Waxer/Polisher will not operate properly if the battery pack is not seated properly.
OPERATING THE WAXER/POLISHER
Be aware that this tool is always in an operating condition because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bonnets or servicing.
BEFORE USE:
• Make sure the car is clean. Wash thoroughly to remove all dirt and road film. Waxing a dirty car will scratch the car’s finish.
CHARGE BATTERY PACK:
1.Plug the charger into the nearest 120 volt electrical outlet. The step of the battery has positive and negative terminal markings on it. Align the markings with the identical markings on the top of the charger base. Insert the battery pack into base. Pack will not insert properly if reversed.
2.Make sure the trigger on the Cordless Waxer/Polisher is in the “OFF” position and remove the battery pack from the Cordless Waxer/Polisher.
BATTERY PACK
BATTERY
CHARGER
• Remove the battery pack to prevent acciden- tal starting.
• Turn the waxer upside- down with the foam pad facing up.
•Slip the synthetic wool bonnet over the foam pad. Tuck the elastic down evenly around the pad so the bonnet will not come off while in use.
3.If, when first inserting the battery pack, the red “ON” button does not light up, press the “SET” button on the charger. When the battery is charging, the red light is “ON”.
13 | 14 |
