Kawasaki 840457 instruction manual Waxing, Polishing, Maintenance and Cleaning, Accessories

WAXING

The bonnet will absorb the wax as you work. Reapply as necessary.

•Never apply wax in direct sunlight.

• Wash and dry vehicle before waxing.

• Make sure you have a firm grip on the waxer/polisher before switching power ON.

•NEVER press down on the waxer/polisher. Move over the surface with light, sweeping strokes.

•Using a crisscross pattern,

work your way across the broad, flat surfaces of the car first. Move across the hood, over the roof, down the trunk and around the sides.

POLISHING

•Slip the terry cloth bonnet over the foam pad, making sure that

the elastic is securely tucked around the pad.

• Polish surfaces in the same order that you waxed them.

• Hard-to-reach areas can be polished by

hand. Slip the bonnet

over your fingers and polish in small circles,

working your way around door handles or under edges.

MAINTENANCE AND CLEANING

Always remove the battery pack before attempting cleaning or maintenance.

Do not use paint thinner or any other chemicals to clean the waxer/polisher case. Harsh solvents may damage the plastic. Use only mild soap and water for cleaning.

Clean vents frequently. Keep clear of all dirt and obstructions.

Wash bonnets in warm soapy water. Do not use harsh detergents. Air dry complete- ly before use.

Worn bonnets may be replaced with any standard 7-8" bonnet.

ACCESSORIES

Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.

Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.

If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current necessary for your power tool. If not, your tool may experience a loss of power, excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord (see table on next page).

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS

TOOL CURRENT RATING		CONDUCTOR SIZE IN A.W.G
AMPERE	10FT.	25FT.	50FT.	100FT.
3-6	18	18	18	18
6-8	18	18	18	16
8-10	18	18	18	14
10-12	16	16	14	14
12-16	14	12	12	-
16-20	12	12	12	-

15 16