CHARGING BATTERY PACK
ADJUSTING THE WORKLIGHT BEAM
CHARGE BATTERY PACK:
1.Make sure the trigger
on the Cordless Worklight is in the “OFF” position
and remove the battery pack from the Cordless Worklight.
2.Plug 120V AC Adapter into household outlet and into side of battery charger. Insert battery pack into battery charger. When the battery is
placed in the charger, the red LED indicator light will remain on.
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER
Hold the handle of the Worklight securely in
one hand. With the other hand, swivel the head 
UP of the Worklight
the angle you desire. Swivel the head of the Worklight clockwise to return it to its original position.
3.When fully charged, reattach battery pack onto Cordless Worklight, making certain latches fasten securely. Cordless Worklight will not operate properly if the battery pack is not seated properly.
OPERATING THE WORKLIGHT
Parts of this Worklight heat up almost immediately when in use. To avoid burns, use caution when handling light bulb and metal reflector. Never change a hot light bulb. Bulb must be cool to the touch before attempting to remove or replace it.
OPERATING THE ON / OFF SWITCH
Press the “ON/OFF” switch to turn the worklight “ON” and “OFF”.
REPLACING THE LIGHT BULB
This Worklight uses a Krypton 19.2V, 0.6 A light bulb. Use of any other kind of light bulb may cause damage or injury.
Parts of this worklight heat up almost immediately when in use. To avoid burns, use caution when handling light bulb and metal reflector. Never change a hot light bulb. Bulb must be cool to the touch before attempting to remove or replace it.
For your convenience, a spare light bulb is included inside the unit. Unscrew the rim and carefully remove it from the light assembly.
9 | 10 |
