When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or KICKBACK may occur. Investigate and take corrective actions to eliminate the cause of blade binding.
When restarting a saw in the work piece, center the saw blade in the kerf and check that teeth are not engaged into the material. If saw blade is binding, it may walk up or KICKBACK from the work piece as the saw is restarted.
Support large panels to minimize the risk of blade pinching and KICKBACK. Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel.
Do not use dull or damaged blade. Unsharpened or improperly set blades pro- duce narrow kerf causing excessive friction, blade binding and KICKBACK.
Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it will cause bind- ing and KICKBACK.
Use extra caution when making a “Pocket Cut” into existing walls or other blind areas. The protruding blade may cut objects that can cause KICKBACK.
SYMBOLS
IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer.
SYMBOL | NAME | EXPLANATION | |||||
|
| V | Volts | Voltage (Potential) | |||
|
| A | Amperes | Current | |||
| Hz | Hertz | Frequency (Cycles per Second) | ||||
| W | Watt | Power | ||||
| Kg | Kilograms | Weight | ||||
|
|
|
|
|
| Alternating Current | Type of Current |
|
|
|
|
|
| Direct Current | Type of Current |
|
|
|
|
|
| ||
|
|
|
|
|
| Alternating or Direct Current | Type of Current |
|
|
|
|
|
| Earthing Terminal | Grounding Terminal |
|
|
|
|
|
| ||
|
|
|
|
|
| Class II Construction | Denotes Double Insulation |
| min | Minutes | Time | ||||
|
| s | Seconds | Time | |||
9
SYMBOL | NAME | EXPLANATION |
Diameter | Size of Drill Bits, | |
|
| Grinding Wheels, etc. |
| No load speed | |
.../min | Revolutions per Minute | Revolutions, Surface Speed, |
|
| Strokes, etc. per Minute |
1,2,3, … | Ring Selector Settings | Speed, Torque or Position Settings |
FUNCTIONAL DESCRIPTION
Be aware that this tool is always in an operating condition because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.
8 | 7 | 9 |
|
| 2 |
10 |
| 1 |
| 6 |
| 3 |
|
|
| |
| 11 |
| 5 |
| 4 |
| |
CONTROLS AND COMPONENTS: | 8. |
| |
1. | Battery Pack | 9. Rubber Grip |
|
2. | Release Buttons | ACCESSORIES: |
|
| on Each Side | 10. Saw Blades (2) |
|
3. | 120V AC Adapter | 11. Rip Fence Guide |
|
4. | Charger | COMPONENT | MODEL NUMBER |
5. | LED Charging Indicators | BATTERY PACK | 690071 |
6. | Saw Shoe | CHARGER | 690507 |
7. | Trigger Switch | SAW BLADES | 690086 |
