1.Remove power to the band saw by turning the switch off and unplugging at the power source.
2.To open the upper housing door, turn the upper housing locking screw to the left and then (pull) the door open.
3.To open the lower housing door, turn the lower housing locking screw to the left and then (pull) the door open.
1.To adjust the height of the upper blade guide loosen the blade guide locking knob and
then adjust the height using the blade guide adjustment knob.
2. Tighten the blade guide locking | 1/8" |
| |
knob to secure the upper blade |
|
guide in position. |
|
CLOSE
OPEN
ADJUSTING THE UPPER BLADE
The upper blade consists of a thrust bearing that supports the band saw blade from the rear and two guide bearings that provide lateral adjustment. These guide bear- ings need to be adjusted after every band saw change or any tracking adjustment. The upper blade guide protects against unintentional contact with the saw blade.
For the upper blade guide to provide adequate protection against contact with the band saw blade, it must always be set as close as possible against the work piece (maximum distance 1/8 inch).
Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments. Failure to do so can cause electrical shock, injury or death.
ADJUSTING THE THRUST BEARING
The thrust bearing must be adjusted after every band saw blade change or tracking adjustment.
1.Loosen the thrust bearing locking screw with the Allen key supplied.
2. Adjust the bearing position until it is
3. Tighten the thrust bearing locking screw.
1/32" FROM BLADE
15 | 16 |
