VARIABLE SPEED TRIGGER SWITCH
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Drill depends on the amount of pressure you put on the trigger.
• The more pressure you apply, the faster | TRIGGER |
SWITCH | |
the Cordless Drill will go. |
|
• Release the pressure and the Cordless Drill |
|
will slow down. |
|
FORWARD / REVERSE AND TRIGGER LOCK LEVER
Be sure the trigger is released when changing the position of the lever. Always store the tool in the “LOCKED/OFF” position.
Always check the direction of the Cordless Drill's rotation before use.
TO SELECT THE DIRECTIONS
OF ROTATION:
• To select forward Cordless Drill rotation, press the trigger lock
from left to right flat against the Cordless | TRIGGER | |
LOCK | ||
Drill body. | ||
| ||
• To select reverse, press the trigger lock |
| |
lever in the opposite direction. |
| |
• The center position locks the tool. |
|
TORQUE SETTINGS
To prevent damaging the tool or driving screw too deep into work piece, release the trigger when you feel the clutch slip.
13
THE CONTROL RING ADJUSTS THE LEVEL OF TORQUE: | CONTROL RING |
• For light duty work, use lower settings. |
|
• For heavy duty work, use higher settings.
PROPER SETTING FOR DRIVING SCREWS: 1. Set the ring on the lowest
setting to begin.
2. | Try tightening the first screw. |
|
|
| If the drill drives smoothly, |
|
|
| proceed with the next screw. |
|
|
3. | If the Drill’s clutch slips, |
|
|
| increase the torque setting |
|
|
| and try again until the Drill |
|
|
| drives the screw without incident. |
|
|
| HIGH/LOW SPEED (GEAR) SHIFTING |
| |
FOR LOW SPEED SETTING: | LOW SPEED | HIGH SPEED | |
• Slide the switch on top of the Drill to Position 1 for high torque applications and driving screws.
FOR HIGH SPEED SETTING:
•Slide the switch to Position 2 for light duty projects.
SCREWDRIVING
WHEN DRIVING FASTENERS:
•Always start slowly and gradually increase the speed of the Drill.
•Release the trigger when you feel the clutch slip.
•Always keep the driver bit straight to prevent damage to the screw.
•Hold the Drill with both hands to ensure control if the bit should stick or slip.
•To prevent wood from splitting, drill pilot holes into the wood before driving
in the screws. | 14 |
